

Extremely simple configuration of individual phase FPI through software tool and a radio dongle. No need to connect to RTU

| Item | Description |
|---|---|
| Network voltage | 6 kV to 70 kV |
| Conductor diameter | 150sqmm wolf support (0–35 mm) |
| Current range | 3[A] ~ 800[A] |
| Detection | Voltage & Current |
| Fault type | Inrush, Transient, Permanent |
| Fault confirmation | 3[S], LED + Communication (RF + GPRS) |
| Mode | Sleep, Active |
| Reset | Laptop, Magnetic (manual), Remote controller and Auto reset |
| Indication | Red flash (360°) / 40 lumens |
| Setting item | Gr ID, Pole ID, F(Hz), Fault current limit, Fault detect time, Total LED operating time, LED operating interval |
| Data storage | Events |
| Time synchronize | GMT |
| Protection | IP 55 IEC 60529 :2006 |
| Operating temperature | -20 ~ 70 IEC 60068-2-1, 60068-2-2 |
| Vibration test | IEC 60068-2-6 |
| Salt fog and humidity | 60068-2-52, 60068-2-30 |
| EMC immunity | EN 55011, IEC 61000-4-2, -4-3 |
| Dielectric test | kV/50 Hz – 60s (IEC 60694) |
| Short-circuit withstand | kA/170ms (IEEE Std 495) and 12.5 kA/1s (ANSI 495) |
| Trip Time | 50Hz (40ms), 60Hz (33ms) |
| Battery life time | 19,000mg / 5 years (Depends on fault frequency) |